atcomsystems.ca/forum Forums TDM Business Telephone Systems Mitel Telephones & Systems PRI

I am remotley programming an SX200 ICP for someone and have the PRI up and running and DIDs working. However, the C-Lec that provided the PRI is telling tech on site that PRI circuits only deliver digits (for caller ID outbound) that are dialed on the circuit. This is only the second PRI I have done and am not all that familiar with them. If the above is true is there a way for me to deliver the main number or business name on outbound calls. I can't make a lot of sense out of what I find in the manual.
This PRI is embedded in the contol platform (if that makes any difference).

Thanks,
Dane

In IMAT set up there is option that allow you set up company's indentification number.

This is an imbedded PRI so do not use IMAT to program the PRI

MX or CX?

Try this.

Calling Party Number (CPN) Substitution
Description
The CPN substitution feature provides calling party identification for outgoing calls for purposes of network identification and call back. This feature is available for onboard digital trunk modules (Dual Link T1/E1 Dual Framer and T1/E1 Combo). CPN substitution can also be programmed on PRI cards and NSUs using IMAT (see Using the ISDN Maintenance and Administration Tool).

When a call is made using a route for which CPN is enabled, the system will attempt to replace the caller's extension number with a CPN. If none is found, the system will attempt to use a tenant-based default CPN. If both attempts fail, the call will be made with the original extension number.

Feature Availability

Click here to see a list of the phones that can use this feature.

Conditions

The following conditions apply to this feature:

• SX-200 ICP requires a Dual T1/E1 Framer module (MX) or T1/E1 Combo module (CX/CXi) with PRI.
• This feature applies to only embedded PRI, not to offboard PRI NSUs and PRI cards in Peripheral cabinets.
• This feature is not available with Direct Trunk Select (DTS).
• If an embedded PRI module is added to a system that already has offboard PRI NSU, Form 22 (ARS: Modified Digit Table) will require two entries: one for the embedded PRI trunks (with CPN enabled), and another for the PRI NSU trunks (with CPN disabled).

Programming

In Form 54, Calling Party Number, enter CPNs to replace extension numbers for outgoing calls. Use range programming to assign a single CPN to a block of extension numbers.

(Optional) In Form 19, Call Rerouting Table, program default CPNs for tenant groups.

In Form 22, ARS: Modified Digit Table, enable CPN for the entry that applies to embedded PRI (Dual Link T1/E1 Dual Framer and T1/E1 Combo modules), and disable CPN for the entry that applies to offboard PRI cards and PRI NSUs.

Operation

None.

Thanks.