atcomsystems.ca/forum Forums Other TDM Phone Systems Nitsuko-Tie Telephones & Systems Buscom

Two things (1) Does anyone know the default password for the small buscom system that looks like a onyx vs? I don't have the ver. at the moment. and (2) is there a feature that allows a user to call in thru the voice mail after hrs and make a page thru the phone speakers?

thanks, dave

We can't post passwords on the board. Make sure you have a good email address in your profile and someone may email you. As far as your second question. No, it can't be done.

See:
https://www.sundance-communications...amp;End=2453006&Session=2452683.0911

and
https://www.sundance-communications.com/forum/Forum1/HTML/000174.html



[This message has been edited by test-ok (edited February 12, 2003).]

Are you working on a DS01 and what type of Voicemail

[This message has been edited by SSPhone (edited February 12, 2003).]

It almost has to be a DS if it's not a Onyx VS.
As far as calling in and doing a page over the speakers you can't, and you should be able to program from Station 300 or any other set programmed with access level 04.
But station 300 is level 05 and can not be changed so you can always program from it.

The newer DS1000/2000 with the Vangard Voice Mail will do Park and Page.

[This message has been edited by dtmf (edited February 12, 2003).]

The DS1000/2000 with the Vanguard VM is an incredible system. I wish this was around before I got hooked on 'shiba and that crappy flash vm.

This system installs and setups so easy, I didnt think Nitsuko (TIE) had it in them. But I still like the Black & White Ultracom's the best....not the CX

If you have some extra ports open on the machine, you may be able to loop around a single line port to a co port. I am pretty sure you can do this but I don't have a manual to confirm this.

Set up a single line port to be wired into a co line. Don't forget to create the extension in voice mail for the transfer. Make the co line a DISA port access. Once you put the DISA pass code in, you should get intercom tone and be able to dial the page code.

Once again, I don't have a manual in front of me so I can't confirm this. In theory it should work. I have this scenario working on a Vodavi system.

Also, depending on the voice mail, you could do the Park and Page. This can work if you can program the voice mail.

[This message has been edited by A6 (edited February 15, 2003).]

For single lines on the DS or Onyx you need to have a ASI(Analog Station Interface)unit, and there is no way to loop to a co line.