atcomsystems.ca/forum Forums Other TDM Phone Systems Telrad Telephones & Systems Meet me Conferencing

I am trying to set up a line where someone can dial a dn (outside and internally) for a conference call.
How do you set up a meet me DN?
Also, is it possible to put a password for the conference call so that not anyone can get in the conference?

Erik, check this out.

This is what I set up for our company. I set a DID to point to Tenant 4 vm. recorded greeting such as " thankyou for calling our conference call line. Please enter your 4 digit code now."
Participant enters code(which is really just a DN) and is connected to call.

Go to System Parameters, Function Access Codes. Scroll down to Meet Me Conf. No. Program all 5.
Call the DID and enter one of the codes to test.

We have had this setup for 4 months and is working great! Each time someone needs to make a conference call, I program a new code for that call. Users think the code only works for their call at the assigned time.

This is great for keeping Conference Calls secure.

Keep in mind:
-Only 8 OUTSIDE parties can be involved in one call.
-If you have a limited number of outside lines, Keep tabs on how many outside parties are in each call at one time.
-MUST HAVE A SOURCE 1 MODULE FOR THIS APPLICATION ON VERSION 7 AND BELOW.

For internal calls, participant need only dial the code from phone. Just like dialing another extension.

You need conf bridge.

That is the Source 1, right?

Yes or a license on the MPD2 or Ipex.

I programmed FLNP "5" for "Meet Me Page"

Now I walk to an idle station, dial 5, and say "Liz, Please dial 5" and she meets me on the page.

and a 3 digit ext number for conference bridge with a DID pointed to it for external.

I got him set up per my instructions above. had to program appgen for him. He said it is working great.