|
|
Joined: Jul 2010
Posts: 70
Member
|
OP
Member
Joined: Jul 2010
Posts: 70 |
I have a Elite192 with a T1 that needs to be upgraded to PRI. What needs to be done in the programming to make the PRI work ?
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
|
Joined: Jul 2001
Posts: 1,985
Moderator-Mitel, NEC, Vodavi
|
|
Moderator-Mitel, NEC, Vodavi
Joined: Jul 2001
Posts: 1,985 |
Back the T1 out of programming. Add the PRI card in programming. Replace the T1 card with a PRI card & program. The DID routing should still be in place. I think PRI's are supported in v3000 or higher software & get installed in a specific slot.
|
|
|
|
|
Joined: Jul 2010
Posts: 70
Member
|
|
OP
Member
Joined: Jul 2010
Posts: 70 |
After I change the T1 card to PRI is the trunk group for outgoing still in place or do I have to set this up ?
How do I tell what version it is ?
Thanks
|
|
|
|
|
Joined: Apr 2007
Posts: 1,439
Member
|
|
Member
Joined: Apr 2007
Posts: 1,439 |
You're going to need to remove the DTI card, then remove the DTI programming in progrms 1-11-xx, then delete the card in 7-1.
Then you'll need to add a PRT-u20 card, program it in 7-1 and setup in 1-13-xx.
Program your trunks in 3-14, 3-91, 3-03, 3-04, and do your DID setup in 1-1-20/21/22
D
|
|
|
|
|
Joined: Jul 2010
Posts: 70
Member
|
|
OP
Member
Joined: Jul 2010
Posts: 70 |
Thanks,
Is the wiring for the PRI the same on the MDF terminal as the T1 ?
|
|
|
|
|
Joined: Apr 2007
Posts: 1,439
Member
|
|
Member
Joined: Apr 2007
Posts: 1,439 |
typically, yes.
you may have to flip your tx and rx pairs depending on how the provider is dropping it off to you.
D
|
|
|
|
|
Joined: Jul 2010
Posts: 70
Member
|
|
OP
Member
Joined: Jul 2010
Posts: 70 |
|
|
|
|
|
Joined: Jul 2010
Posts: 70
Member
|
|
OP
Member
Joined: Jul 2010
Posts: 70 |
I programmed the PRI, under PRT channel map assignment all the channels are greyed out. Is this normal or did I miss something ?
|
|
|
|
Forums84
Topics94,289
Posts638,795
Members49,767
| |
Most Online5,661
May 23rd, 2018
|
|
|
0 members (),
141
guests, and
388
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
