|
|
Joined: Jul 2003
Posts: 1,231
Member
|
OP
Member
Joined: Jul 2003
Posts: 1,231 |
My customer has a Nortel 616 feeding to a newer Viking PA2A amp. The audio out goes to a Bogen TPU-15A and on the Bogen com and 70v screws to the two horns. Viking also has co lines to modular ports for ringing. When they page it gets a hum that sometimes lasts after handset hung up. When a call rings in it hums as well, sometimes a minute or so after call is answered. Does anyone have an idea on this. Thanks Dave.
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
Joined: Feb 2005
Posts: 12,343 Likes: 3
Member
|
Member
Joined: Feb 2005
Posts: 12,343 Likes: 3 |
Is this something that recently happened or has it been that way since some hack installed it or changed something?
Exactly how is the Viking connected to the Bogen? What kind of wire and to which terminals on both?
What happens if you pull the CO line plugs and do a page?
What happens if you disconnect the page input and call a CO line?
-Hal
|
|
|
|
Joined: Jul 2003
Posts: 1,231
Member
|
OP
Member
Joined: Jul 2003
Posts: 1,231 |
it started doing it a while back they tell me and they replaced the pa2a and it was ok for a while and then started again. if i take the co lines out of the viking it wont hum on ring in. the jumper goes from the ksu to the page screws on the viking. and then jumper from the horn screws on pa2a to the bogen incoming screws. and from the bogen to the speaker cable going to the horns.
|
|
|
|
Joined: Feb 2005
Posts: 12,343 Likes: 3
Member
|
Member
Joined: Feb 2005
Posts: 12,343 Likes: 3 |
if i take the co lines out of the viking it wont hum on ring in. Ok. How about a page with them disconnected? Does that hum? The Viking and the Bogen should be with each other. The output of the Viking is the 600 ohm audio out (7&8) that should be connected to the Bogen T&R with a twisted pair or preferably 2 conductor shielded cable. Shield goes to the GND screw on the Bogen. -Hal
Last edited by hbiss; 10/13/15 01:59 PM.
CALIFORNIA PROPOSITION 65 WARNING: Some comments made by me are known to the State of California to cause irreversible brain damage and serious mental disorders leading to confinement.
|
|
|
Forums84
Topics94,284
Posts638,772
Members49,765
|
Most Online5,661 May 23rd, 2018
|
|
0 members (),
144
guests, and
336
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|