What software do I need to talk to a telrad connegy unite ip system? Does it just have a GUI interface or do I need special software?

You need the software to talk and program the switch. Do you know what release? I would assume 3.1.0.8 would work it's called eManager along with a gate way.

I don't know what software release. It is only about 2 years old. The main cars is an ipex2, 6 uld cards, 1pri, 1 ons, and 1 hons card. What is the gateway?

The gate way is in with the software when you put it on your pc/laptop, it's basically a connection wizard.

I found the disk on the shelf. Now I see what the gateway is. Now I just need the manual. Thanks for the help Russ.

The manual is on the CD. Start EManager and click HELP.

I am stuck at the password, which I know we can't post here.

PM sent

Emanager password or system password?

So now I need to access the voicemail. I have found that I need emaGEN WebController. Anyone know where to get this?

Try and set-up a new post in the future.

It's the IP address of the Voice Mail.

Shawn
Is the voicemail on the network?

I don't think it is, there are no patch cables connected except for the one that is connecting to the PRI card. The voicemail appears to be riding on the IPEX 2 card. There is no external box for VM.

The network connection for the voicemail is near the bottom tab, below the USB ports. If it's never been on the network you will need a monitor and PS2 keyboard to connect to the IPeX to set the IP address to get it on the network. I see this often and wonder why the installer didn't put it on the network but you can use a cross over cable and connect direct to it but you still need to know the IP address so you will still need the monitor and keyboard.

Can someone please PM me the default password for emanager.

Thanks.