I guess we have some floppies that went bad, because I have a tech who is unable to install a version of the Sprint Protege programming software.
Does anyone have MTX/LTX R72UF5.F20 that you could send to me? Thanks!

------------------

| Signal Communication Systems - Fresno, CA |

| Telephone Systems, Voicemail Syste... & Data Cabling - Central Valley, CA

Do you still need that rmp software?

Sure, if you have that one. I never did get a response from anyone else. Thanks!

------------------

| Signal Communication Systems - Fresno, CA |

| Telephone Systems, Voicemail Syste... & Data Cabling - Central Valley, CA

You have mail. Hope your server will allow an exe. program If I get it returned I will rename it and resend if it is not an exe rename it as such and you should be ok
John

Got it! Thanks!!

------------------

| Signal Communication Systems - Fresno, CA |

| Telephone Systems, Voicemail Syste... & Data Cabling - Central Valley, CA

I need to see if I can get another one. This is how we have it written down on the KSU, so I'm not sure if it's accurate.

K72UF3.F38

I had never seen a K before, so it may in fact be an R. Anyway, if anyone has this one and can help me out, I'd appreciate it!

------------------

| Signal Communication Systems - Fresno, CA |

| Telephone Systems, Voicemail Syste... & Data Cabling - Central Valley, CA

The eproms are labeled with a k but the software is r you have mail john

[This message has been edited by frodo_35 (edited May 05, 2005).]

Cool! Got it. Thanks, again!!

------------------

| Signal Communication Systems - Fresno, CA |

| Telephone Systems, Voicemail Syste... & Data Cabling - Central Valley, CA

[This message has been edited by 5years&counting (edited May 05, 2005).]

does anyone know how to use the protege programming software to activate the outcall notification feature?

I tried to connect to the system by a serial port. Got a "Fail to connect" error message.