Guys, can any of you help me out with shutting off dhcp on the 3448. I'm just learning and was given the 3448 for training purposes and can't find anywhere in the manual how to shut DHCP.
I tried to put it on our network and found out the next morning that DHCP was turned on(ouch!).
Any help would be appreciated
This adtran manual is over 2500 pages, ouch! Go to index and look for DHCP. If its not accessable thru the GUI, which I doubt, then CLI is the other route.
Yeah, you are going to likely need to get in through the CLI. It uses the same settings as a Cisco router, 9600, 8, N, 1
Jeff
no service dhcp
!
GUIs are evil use CLI!
I'm using the CLI and tried the no sevice DHCP and got nothing.
Is the 3448 one of the newer models with a GUI?
You most likely need to enter configure terminal.
It has a GUI, but I can't add it to the network because it is handing out addresses, I guess I could put a netscreen in front of it and MIP to it. Yup, I'm in config t, you would think it would be pretty simple command, could it be as simple as adding a ip address to the default vlan and that would stop DHCP service.
Do a show run on the serial port, find the DHCP scope definition, config term, no dhcp whatever you found for the definition.
Thanks, I will give that a try and let you know.
For those who care the way to turn off DHCP on the Adtran was easy as I expected, I'm slow. All that needed to be done was DHCP pool name shut. There was a DHCP pool created so I just had to shut it. DHCP is off by default until you add DHCP pool and name it.
Thanks for all your guys help