I've got a 7 node sx200 with a Pri in a Bay 2 . It's LW19 Q36. It's been fine for a few years but now has dumped the link a few times this week. The reports show too many slips. The Telco has checked from the CO and says all is fine, they're sending out a tech to test the line. They may or may not find a problem, a typical telco dilemma.

Is there a way to increase reliability on the link even if it's getting some slips.

I've found that a power cycle on bay 2 always seems to fix the problem but that's not a good long term solution!

Thanks
Bill