I am attempting to do two types of forwarding.
1: Forward all calls to another extension, from the operators console. (ext: 300)
2: Forward all calls from extension 300 off premise.

I have set up this system to allow forwarding int the COS. However, I have not had any success doing this as of yet.
The manual says to press intercom, dial # and then 9 i believe, but when I do this I get a display of DSS Select 6,9,.8. And calls do not forward.
The system is an ONYX VS Hybrid.
Thank you.

Everyone should believe in something.................

I believe I will have a beer.........