|
|
Joined: May 2004
Posts: 108
Member
|
OP
Member
Joined: May 2004
Posts: 108 |
I have a Flash that will not allow me to re-record a path. I have disabled tree 1 (I am sure that it is disabled because I have to go back and enable it in order to get CCR to work again). I have tried to disable tree 2 in case I was using the wrong tree (It said it wasn't active). I have checked tree 5 to see if I am exiting incorrectly. When I check tree 5 the recording is not in there. One thing that I can not figure out is when I go into CCR to record the path (after I have disabled the tree) it will flash enabled after one of the steps. I am sure that it is something that I am missing. But I read the manual and went back out today and it still would not take. Any advice would be appreciated.
|
|
|
Nortel Phone System Service in Canada
Do you need a Nortel Phone System technician or specific Nortel parts?
Atcom to the rescue! Our telephone techs have qualified experience servicing and troubleshooting Nortel CICS, MICS, & BCM telephone systems.
Service in Canada from sea to sea.
|
|
Forums84
Topics94,262
Posts638,697
Members49,757
|
Most Online5,661 May 23rd, 2018
|
|
0 members (),
140
guests, and
24
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|