Hey guys,

Have a questions about a voice mail program I have and its answering system. When some one first calls in we get a 3 to 4 second delay before the answering system answers and starts working. I was told it was because of the caller id function being on. I have gone through the manual and used program *50 to turn all caller id function off.

*#*#1*2*3 spk *50 hold spk 001-016# then used led button 01 to erase data hold spk ## hold spk ## hold

then ran program 91-2 to move date from temp meme to working mem.

but this did not cure my problem.

any suggestions.

k424 system with 2 cabinates
first cabinate is as followes

processor rctuc3 first slot
processor rctud3 second slot
rsiu1 third slot
pdku2 fourth slot
pdku2 fifth slot
pdku2 sixth slot
pdku2 seventh slot
rstu2 eighth slot

cabinate 2 is as followes
rstu2 first slot
rcou1-rcos1 second slot
rcou1-rcos1 third slot
empty fourth slot
pdku2 fifth slot
pdku2 sixth slot
empty seventh slot
empty eighth slot

16 total inbound lines (co lines)

stratagy 4 voice mail and answering system. running dos6.22 it works fine but just has the 3 to 4 second delay when dialed directly into from one of the phones or from outside line.

Dont know if it is a system issue or a voice mail issue. I think it is voice mail but not sure. Will post this in voice mail queue also.

Thanks for your time.