Problem: Caller ID not showing up on display.

Equipment:
Two XTS cabinets
Three MISB24 digital cards
One MISB12 digital card
Five LCOBC with Caller ID unit installed


Eight analog lines ring into 8 port digital Dispatch.

Problem: When Dispatch transfers lines- no Caller ID appears on display.

ü Caller ID tones are present between first and second ring on analog CO line
ü Ring delay is set for 7 seconds
ü Programming FLASH 56 = [1] On, [2] YES, [3] 9600, [4] (port) 5
Note: All ports 1 to 5 were tried with no success.
ü Baud Rate FLASH 15 set to 9600
ü Flex button assigned Code 653 (Caller ID Name/Number)

The FLASH 56 seem to deal with connecting an external ICLID unit. With On board Caller ID on the CO card should button [1] be set to off?