I mentioned once before that I didn't trust PCDBA F17 and I lost three days fighting it...it wasn't my system or programming, rather it was the F17 causing the problems.

To prove to myself what was happening, I programmed two cabinets with the K17 firmware loaded using the phone and downloaded the data to two laptops running PCDBA F17.

I set the bottom row of buttons for 816 ~ 821, set some T1 DID translation tables, and directory swapped port 124 with 148. Both systems worked as expected.

I download the data to PCDBA and the buttons showed 824 ~ 829, all the translations tables were blank, and port 30 was mapped to ext. 124 and port 80 was mapped to ext. 148. When I uploaded it back into the cabinets without changing anything, it messed up what I programmed in by hand.

Found out this afternoon this was a known issue with F17 and was told to use the new L18 firmware and PCDBA L18.