Originally Posted by Professor Shadow
Look on page 2-2 of the Manual.

"Note Press F2 in the Serial Port and Baud Rate fields to display a pop-up box with valid entries."

I think it's the correct document.

This is the reason why I didn't try changing the Baud rate:
2-17 "CAUTION! The connection may fail if the baud parameter for this port is set
higher than 9600 or the serial port definitions for this port do not
correspond to the definitions for the COM port being used on the
UADM2 PC."

Originally Posted by phonemeister
You can change the serial port parameters in the system parameters via the Stratagy Admin software. It requires a reboot and then you can reconnect with the higher speed.

Good tip, 9600 is just so slow. I might first try changing the speed on a system on a test bench first. I would hate trying to explain to a customer why I have to default their VM because I can no longer connect.

David
Tele Express Business Systems