I have a hospital that wants all doctor offices in area to route callers
to central location for “New Patients,” 35 are using Cisco.
I have to get 5 sites to do this using auto attendant /analog lines.
3 are NEC, 2 Samsung. I have never programmed Samsung AA.

Need 701-704 to Call Forward Off Premise when 1 is pressed.

What is the best way to do this? Below is what I have programmed
on a Office Serve 100 using SVMi-4e that I have setup at my house
to get familiar with programming the blocks and system.

It seems I would use a station block that is set up as off premise
Q1, Do I need to use the anything in suffix to hang up if it is non supervised?
Q2. Is extension block where the outdial number goes?
Q3. The day menu block I have digit 1 as “GOTO” EXT "401-DougoffP"
or "GOTO" DAL "New Patient"



Station Block type(Off Premise) “NewPatient”
Dialing Strings for 7 [???????], 10,11 digits
Prefix 9,
Suffix

Simultaneous Y
Conf. N
Internal N
monitor transfer N (= blind transfer)?

Extension Block
Extension Doug OffP D
Group 1 number 401

Extension controls
Dial number 3859041
Alternate

Station (Off Premise) “New Patient”

Authorizations cfwd Y enabled Y

Day Menu
Page 2

Option 1 GOTO EXT 401DougoffP
or
Option 1 GOTO DAL Station New Patient

Thanks for taking the time to read it.
Am i on the right track or way off?