I have a customer with two Magix systems connected via a point to point T-1 setup as PRI. The network switch is using the PBX switch for local dialtone accross a PRI. When someone from the PBX switch dials out on the PRI, it displays the base number plus extension like it is supposed to do. If someone dials out from the network switch, it shows up as unknown. It does not even send just the base number. I have tried changing every setting I can possibly think of, but still the same results. Switch numbers are correct.

any one have any ideas?

Z-man
Avaya SME Authorized Partner
www.omniofficetech.com