|
|
Joined: Jun 2009
Posts: 3
Member
|
OP
Member
Joined: Jun 2009
Posts: 3 |
I've attempted to change an existing analog loop into a phantom loop in LD 17. I am not receiving the prompts that are laid out in the documentation.
REQ: CHG
TYPE CEQU
DDCS
TDS
CONF
DTDT
DLOP
PRI2
APVL
DTI2
SYNM
Any suggestions on how to fill in the other prompts after "TYPE"?
|
|
|
|
|
Joined: Jun 2007
Posts: 627
Member
|
|
Member
Joined: Jun 2007
Posts: 627 |
I "think" a phantom loop needs to be loop 159
|
|
|
|
|
Joined: Aug 2004
Posts: 1,476 Likes: 13
Admin
|
Admin
Joined: Aug 2004
Posts: 1,476 Likes: 13 |
I doubt it has to be 159 on an Option 11, but I do think there's a specific range it needs to fall into. I also highly doubt it can be "changed" from a 500 type to a phantom...
I work with a phantom loop on an 81C that's # 156.
|
|
|
|
|
Joined: Jun 2007
Posts: 627
Member
|
|
Member
Joined: Jun 2007
Posts: 627 |
I was able to move a 500 from 159.X.X.X to 36.X.X.X
So it should be able to be moved regardless of the TN.
|
|
|
|
|
Joined: Jan 2004
Posts: 82
Member
|
|
Member
Joined: Jan 2004
Posts: 82 |
The phantom loops are set up in LD 97. You'll have to check the NTP, but I believe the valid loop numbers are 96, 100, 104,... Then the phantom / virtual sets are on "cards" in the 60s and 80s. Make sure you have the NTP books to refer to, or you'll have problems!
|
|
|
|
Forums84
Topics93,877
Posts636,991
Members49,670
| |
Most Online5,661
May 23rd, 2018
|
|
|
|
![[Linked Image from web.atcomsystems.ca]](http://web.atcomsystems.ca/pic/atcom_logo_60px-high.png){kind=logo}
