atcomsystems.ca/forum Forums Other TDM Phone Systems Telrad Telephones & Systems MDN Group

In the past I was able to create mdn groups with no problem. However now that I try to go into MDN Groups, i get an error that reads:

Invalid entry = 699, varname = mdn_pbx_dn_st_or_map_log

how do I create an MDN group with this error coming up every time.

Is this in e-manger or pcp. Is it when you try to create the group or when you goto that part of programing.

Quick Respons:
Sounds like you need to re-instal the software on your PC.

This is in Emanager. It is when I try to create it, by going into MDN Groups right above Hunt groups.
Is there a different way of imputting it on Emanager. I want to create an MDN with an analog line.

It happens when you click on MDN GROUPS with your mouse.

Then Re-Install, There should be no problem going into that window. You can try an open another CFG, and try to goto MDN GROUPS.

Or is when you try to put in the DN, in MDN GROUPS.
If you want E-mail me the CFG and I see if it works in my e-manger.

My Grammer Teacher would kill me.

I will reinstall it on a different PC and try bringing it up there. I will let you know if it changed anything.
By the way I get the error message when I go to
Station group features
MDN Groups

Invalid Vector Operationemanger

Invalid Entry
VarCode=699, VarName=MDN-pbx_dn_st_or_map_logp


I was not sure if I might have somehow disabled myself from configuring MDN groups.
Anyways, i will test it out on a differnt pc and let you know if I had any luck

I reinstalled a later version of Emanager on my pc and just turned it on, and when I went into MDN groups, I got the same error message again. It does it with older Emanager software and newer one also. I can not even go into MDN groups offline as I get the same error message.

Did you try a diffrent CFG? What version of e-manger?

Older Version
The emanager version 1.16.0.6
The emanCom version 1.12.0.1
Unite Gateway API version 1.0.0.3

Newer Version
The emanager version 3.1.0.4
The emanCom version 1.14.0.8
Unite Gateway API version 1.0.0.4

I created a backup with different CFG and I had no luck. I am still getting the error message.

However, if I close out cfg file and go to new one it works (offline). Is there a way to fix this?

If you try a diffrent CFG and it works fine you probably have a bad CFG file. I see you try to back-up as a diffrent file name and deleted the old file. since the back-up is bad you need to re-program the system from default.
If this is an IPEX or MPD2 I would do this after hours. If it's a 8/18 or 128 MPD do it on one from your stock and just switch them out.

Re program off-line then default the MPD or IPEX card. then do a full system download.

That sucks.

I would also try getting the latest E-manger. I'm at 3.1.0.6

I created a backup cfg with a different file name and I ran into the same problem.
If I re-program the system from default, that would lose personal speed dials, forwarding lines, etc...?
If the file is corrupted there is no way to fix it either?