|
|
Joined: Mar 2012
Posts: 3
Member
|
OP
Member
Joined: Mar 2012
Posts: 3 |
Hi, guys
Can you please help me with getting a manual for DDCB3A box?
Or possibly direct me how to connect it to a maglock?
As of right now i have following:
Toshiba Strata phone system
DDCB3A box with one Toshiba doorphone connected to port A.
I also installed a maglock, with green Push to Exit button and a IEI 212i Door Keypad.
Visitors can ring the doorphone, which i can answer on any phone in the office, but i can't open the door for them which is what i want. So i need to connect the DDCB3A to the mag lock but i dont have a wiring diagram, neither programming instructions if any. Thank you so much for your help.
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
|
Joined: Mar 2001
Posts: 3,869
Member
|
|
Member
Joined: Mar 2001
Posts: 3,869 |
ALWAYS inform us of the system you have, DK16, DK424, CIX28, CIX100, etc.
You can use ONLY certain circuits on each different control unit for door phones.
Here is some info from a DK installation manual:
1. DK40i and DK424: connect PDKU circuit 5 (T/R and PT/PR) to the DDCB HKSU modular
jack (see Figures 10-9 and 10-10).
DK14: connect applicable digital telephone circuit (logical port 02 or 03) to the DDCB KSU
modular jack. See Figure 10-7 and Figure 8-1.
2. Connect the door lock wire pair to the DDCB modular B-jack (pins 3 and 4).
3. Set SW1 to the DOOR position.
4. Set SW2 to the LOCK position.
5. SW3 inside the DDCB can be set to open or close the door lock relay whenever a door lock
button is pressed: if SW3 is in the “1-2†position, the relay closes when the button is pressed;
if in the “2-3†position, the door lock relay opens when the button is pressed.
Note SW3 comes from the factory in the “1-2†position.
6. In Program 77-1, set the door lock activation for three or six seconds and enable the PDKU or
RDSU ports for DDCB connection.
7. In Program 77-2, enable the DDCB B-jack for door lock operation.
8. In Program 39, assign door lock buttons to stations per the customer’s record sheet.
9. Check each telephone door lock button from each station: the DDCB modular B-jack (pins 3
and 4) will momentarily open or close (three or six seconds) when the button is pressed.
THE Bracha, old blond specialist in Rube Goldberg solutions.
|
|
|
|
Forums84
Topics94,287
Posts638,784
Members49,767
| |
Most Online5,661
May 23rd, 2018
|
|
|
2 members (Toner, justbill),
122
guests, and
187
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
