atcomsystems.ca/forum Forums TDM Business Telephone Systems Comdial Telephones & Systems VoIP network issue

I have a MP5000 (rel 212) hub with 3 FXII (rel 197) nodes.
Each node can call the hub and the hub can call each node but the nodes can not call each other.
New install, all the same firmware on the VoIP cards (3A). Can ping all over the place.
Dial plan: Hub 8xxx, Node 1 11xx, Node 2 12xx, Node 3 13xx.
Vmail shows up on the displays, just can't call node to node.
Any ideas?

Sounds like the config is set up point to point instead of point to multipoint.

Rather be Fishing is correct. First thing to check is make sure the hub is set point to multipoint.

Sorry, it is point to multipoint.
Thanks for the help.

Did you get it figured out?

Not yet,
It's a new install and it's kind of weird.
I talked to tech support and they tried but we didn't have any luck.
The third site is being brought up with in the next couple of hours.
To review hub can call node 1, hub can call node 2, node 1 can call hub (has vmail on display), node 2 can call hub (has vmail on display).
When node2 calls node1, it says ext1101 off line
etc.
Thanks

try to telenet into the voip node1 card from node2 should be prompted for login and password.

Sorry maybe I should have gave you more info connect your network connection from either node 1 or 2 to your laptop goto a command prompt type telnet and the other nodes ip address. You should be prompted to enter a login {edited} and password {edited). This will show you any errors occuring. You can also check voip card errors by directly connecting to the serial port on the voip card but don't change any parameters without checking with tech support first.Also check ip link boards in vmmi and look at the tcp and tcp remote ports.

What software are you running in each location. 17E? Also do you have all the locations ext's loaded as network extensions?. Although it is too late for this one I always try and setup a network install at my office first before sending it out. Makes it much easy to trouble shoot. Let me know how you make out.

Jim Hoey
SST Communications
Long Island, New York

WV-I am able to telnet into any of the VoIP boards, what error should I look for?
As I mentioned earlier, I can call from the Hub to any node. just not node to node.

CJ
Hub is 211 (MP5000)
Nodes are all 17E
All node extensions are loaded.
We did not set the WHOLE system up (hub and nodes) because the hub was an upgrade from FXS but we set up each node and tested to hub before deployment, we could have however taken all nodes to the hub and tested their. Lessons learned the hard way I guess.

Thanks all for you help and advice, please keep sending it and I will update on progress.