Phone Systems

Sponsored by Atcom
Get a free phone!
Previous Thread
Next Thread
Print Thread
Rate Thread
Joined: Jun 2013
Posts: 7
Member
OP Offline
Member
Joined: Jun 2013
Posts: 7
I am installing an EPM II, one of the more recent Indoor/Outdor RFID readers, and I am not sure which wires need to be connected to what. I know in the older ones, the station wires go in 1 and 2, and so on. On this one, the wires are attached to the circuit board and I need to know which is the common and NC connectors. Also, does the EPM II have a jumper to switch it from NO to NC? Any help would be greatly appreciated. Thanks!

Joined: Jan 2007
Posts: 1,217
Member
***
Offline
Member
***
Joined: Jan 2007
Posts: 1,217
Yellow leads to ESI extension port.
White to strike plate.
NO/NC jumper is on the main board of the unit, manual will tell you exactly how to change it from no to nc.


Aaron
Joined: Feb 2006
Posts: 1,716
Member
***
Offline
Member
***
Joined: Feb 2006
Posts: 1,716
In the box with the new reader is the instructions and wiring detail. Don't be afraid to cut the wires to make them shorter. Many times there's not enough room behind the reader to accommodate all that length of wire.

Rcaman


Americom, Inc.
Where The Art And Science Of Communications Meet

Moderated by  5years&counting, nonameyet 

Link Copied to Clipboard
Forum Statistics
Forums84
Topics93,375
Posts634,588
Members49,525
Most Online5,661
May 23rd, 2018
Popular Topics (Views)
Today's Birthdays
apexnetworks, blpogue, Hillyard, Silversam
Newest Members
NiagaraGuy, Luv2uallday, FredSkidoo, tspa, xtrememachines
49,525 Registered Users
Top Posters (30 Days)
Toner 17
dexman 12
R4+Z 6
Who's Online Now
1 members (Curlycord), 7 guests, and 16 robots.
Key: Admin, Global Mod, Mod
Contact Us | Sponsored by Atcom: Business Telephone Systems Canada | Terms of Service

Sundance Communications is not affiliated with any of the above manufacturers.
©Copyright Sundance Communications 1998-2022
Powered by UBB.threads™ PHP Forum Software 7.7.5