|
|
Joined: Mar 2006
Posts: 57
Member
|
OP
Member
Joined: Mar 2006
Posts: 57 |
One external Valcom 1030C speaker connected to PA extension/ Found defective speaker. Replaced with same model but when I page I hear ring tones instead of voice over speaker. Tried moving PA to a different extension port but trouble followed it. Did a cold restart and re-programmed system but problem remains. Changed Valcom power supply and completely rewired speaker from KSU and power supply to speaker. Polarity is correct on T&R and power. Tried reversing polarity for kicks but trouble remains. I'm thinking a bad KSU. Any suggestions?
|
|
|
|
|
Joined: Nov 2006
Posts: 704
Member
|
|
Member
Joined: Nov 2006
Posts: 704 |
HI! Did u Select PA Equiped under PA Amplifier In programming ?? and assign the Extention connected to the PA??
|
|
|
|
|
Joined: Mar 2006
Posts: 57
Member
|
|
OP
Member
Joined: Mar 2006
Posts: 57 |
Yep. Also tried assigning PA to several different ports on two different cartridges with same result.
|
|
|
|
|
Joined: Nov 2006
Posts: 704
Member
|
|
Member
Joined: Nov 2006
Posts: 704 |
I would connect your test (Butt)set on output of the KSU page port , do a page listen to here the voice announcement , it will be low volume,, if you don't hear the page then likely it is an issue with the the system ,,is this 1 amplified horn or several ?? Is there a separate paging amplifier ??
|
|
|
|
Forums84
Topics93,877
Posts636,993
Members49,670
| |
Most Online5,661
May 23rd, 2018
|
|
|
0 members (),
44
guests, and
17
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
