atcomsystems.ca/forum Forums TDM Business Telephone Systems NEC Telephones & Systems NEC Aspire

I have customer (School) with a Alurtus System

Which is tied into the paging system

Working fine

They can type from there P.C. and it will come over the paging system

They are wondering when someone dials 911

All the phone beep

Can I have that come over the Alurtus System

This is kind of vague

Sorry

OK

I have some more details on this

customer is looking for a relay closer when someone dials 911 ...They just need the closer and they will take it from there

I have been trying to think of a way by using an external relay someone mentioned a wheel lock relay

They have a PRI but there is 1 POTS Line that the system grabs when someone dial 911

I know this seems a little a bit odd but these Alertus systems and others like it are going to be pretty common

Thanks

JD

Look at this.

https://www.vikingelectronics.com/products/ldb-2/

Coral is right - get one of those from Viking and place it on an SLT port on the Aspire. Then in programming set that port to receive 911 notification. That should get you what you need.

How much do I owe you! ....

This should do the trick But wouldn’t I put this on the Analog Trunk
as opposed to a Analog station port

I believe the only thing that use that copper lines is for the 911

I guess if I could use an analog extension that would be good too it’s just I don’t really understand how to do the E911 notification on a Analog extension

I will have to look into that but I’m sure Copperline this is great


Thanks!

I would definitely put this on the SLT rather than the CO line to prevent false alarms.

Test this first, but in the COS of the SLT port enable 20-08-16 (use a 1)
Then in system options set the alarm timer in 21-01-13. I would set it to the max of 64800 seconds.
Then when you want to disable the alarm you just dial 886.

Thanks,
Daniel

Can I use a single line extension to do this ? I am trying to set it up on my test bench

the multi button phones are working but not the single lines

I will have to test it on my bench system. I have done it on the I-Series which the Aspire is based on but it may have changed. I'll have to double check and get back to you.

I was actually testing this on a SL 1100

I do have an aspire I should try doing it on that

I keep thinking they’re all the same