|
|
|
|
Joined: Aug 2002
Posts: 1,070 Likes: 1
Member
|
OP
Member
Joined: Aug 2002
Posts: 1,070 Likes: 1 |
I have a customer with a Magix system. Only 1 call comes into the reception phone. A second call rings 3 times then hits the auto attendant. But the second incoming call will not ring the reception phone. I have a Magix here that I will use to get up to speed. I have WinSPM on a old laptop but I am not sure what I should be adjusting.
|
|
|
|
|
Joined: Jul 2001
Posts: 3,342 Likes: 10
Moderator-Avaya-Lucent, Antique Tele
|
|
Moderator-Avaya-Lucent, Antique Tele
Joined: Jul 2001
Posts: 3,342 Likes: 10 |
Key or PBX/Hybrid mode?
Is Reception configured as an Operator position? DLC or QCC?
In general, in PBX mode, the Operator is a DLC (Direct Line Console) and has line appearances for each line. Are Line 1 and Line 2 assigned to the phone? Both set to Immediate Ring? Abbreviated Ring turned on or off? Can you pull reports from the customer's system?
|
|
|
|
|
Joined: Aug 2002
Posts: 1,070 Likes: 1
Member
|
|
OP
Member
Joined: Aug 2002
Posts: 1,070 Likes: 1 |
Haven't been to this place in long long time so I don't have a record. Most likely DLC.
Going there in a few days. Got my test Magix running with WinSPM. Go into Quick access, telephone programming, feature settings and make sure ringing is set to immediate for outside lines for the operator's extension? Am I on the right track?
|
|
|
|
Forums84
Topics94,284
Posts638,771
Members49,765
| |
Most Online5,661
May 23rd, 2018
|
|
|
1 members (Toner),
134
guests, and
352
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
|
