|
| Joined: Aug 2002 Posts: 997 Likes: 1 Member | OP Member Joined: Aug 2002 Posts: 997 Likes: 1 | I am trying to identify the paging port on a toshiba dk40i. There are only two 25 pairs coming from the ksu to the blocks. The blocks are above a drop ceiling, awful. the paging system is 24v self amplified horns but the wiring is a mess. I read some dk40i manuals and it isn't clear where I can find the page port on the block. Could it be vary based on where this card installed? Customer presses a button on the phone that pages both the phones and the speakers if that helps. | | | | Joined: Dec 2007 Posts: 6,731 Likes: 9 Retired Admin | Retired Admin Joined: Dec 2007 Posts: 6,731 Likes: 9 | Look at PEPU2 External Page Interface Unit on page 7-11/7-12. This should help in tracing the proper cable. Page 8-33 will show you the pin out for the PEPU card. Manual | | | | Joined: Jan 2010 Posts: 927 Moderator-Toshiba | Moderator-Toshiba Joined: Jan 2010 Posts: 927 | The external paging is probably connected to the 600ohm paging output (bottom of the two RCA connectors) bottom right of the main equipment.
In the manual it is page 79 of 766 or section 3-11
Regards Carl
| | | | Joined: Aug 2002 Posts: 997 Likes: 1 Member | OP Member Joined: Aug 2002 Posts: 997 Likes: 1 | Thank you. There is nothing on the RCA connector so I guess on the block (V/S looks about right). This is a big help. Thank you. | | | | Joined: Jan 2010 Posts: 927 Moderator-Toshiba | Moderator-Toshiba Joined: Jan 2010 Posts: 927 | What cards do you have installed in the expansion cabinet on the left hand side?
Regards Carl
| | | Forums84 Topics93,522 Posts635,351 Members49,569 | Most Online5,661 May 23rd, 2018 | |
0 members (),
4
guests, and
10
robots. | Key: Admin,
Global Mod,
Mod | | | |
|