sundance-communications.com Forums Telephony Discussion Phone & VoIP Systems Avaya - Lucent Telephones & Systems hybrid mode partner acs rel. 5.0

Tried unsuccessfully to change ACS to hybrid mode. It wouldn't accept the codes. What am I forgetting.

Could you elaborate on what you have done up to this point. Thanks.

They switch into hybrid mode very easly, As 2-wire said, how did you try it?

It's only a 3 step process, if you haven't installed it yet.
Have you installed and programmed the system and phones yet? Did you remove the PC card?

More info is needed. Please elaborate, as previously requested.

system is installed and programmed. Installed new larger VM and 308 to accomodate growth. Hybrid mode is for the large amount of 6 button phones. I entered the system password and tried #207 #313 #314 #315. I dont remember where to enter the TNECUL password to open up those fields. No i didnt remove remove the PC card. Is that an important step.Thanks

[This message has been edited by bikechuck (edited June 07, 2004).]

Where did you get your info, it's program #198 863285 then 1 for key or 2 for hybrid. It use to be a garded program but now it's in the manual.

Its been a few years since I've done a hybrid like this. Thanks I'll give it a try.

thanks a lot. That was easy and worked fine

Any time my friend