|
|
Joined: Mar 2002
Posts: 3,630
Moderator-Avaya, Nortel
|
OP
Moderator-Avaya, Nortel
Joined: Mar 2002
Posts: 3,630 |
I am having trouble getting a PRI to work on a new install. Everything seems to be programmed correctly according to my notes. The carrier says they are okay. The D-channel is up. When I try to dial out, I get a fast busy. It does not appear I even get to the PRI card as the yellow light never comes on. This is a new Magix 4.0 and a new 100 DCD board. Are there new parameters with the Magix 4? Anyone have any other ideas?
|
|
|
|
|
Joined: Apr 2002
Posts: 646
Member
|
|
Member
Joined: Apr 2002
Posts: 646 |
Do a board-renumber and clear all the alarms. Make sure the carrier is custom. Is ARS FRLs an issue?
[This message has been edited by gkar (edited January 03, 2005).]
|
|
|
|
|
Joined: Dec 2004
Posts: 233
Member
|
|
Member
Joined: Dec 2004
Posts: 233 |
I have a PRI cheet sheet if you need. I can fax a copy to you to go through the steps. It also has some troubleshooting tips on it as well. Send me an email if you would like it.
|
|
|
|
|
Joined: Mar 2002
Posts: 3,630
Moderator-Avaya, Nortel
|
|
OP
Moderator-Avaya, Nortel
Joined: Mar 2002
Posts: 3,630 |
I don't think the FRL's are an issue. I have everything at 3. I did a board renumber and cleared all the alarms. No errors on the D-channel. It never lites the yellow light on the T-1 card. It just gives me a fast busy 5 seconds after I dial a number.
|
|
|
|
|
Joined: Apr 2002
Posts: 646
Member
|
|
Member
Joined: Apr 2002
Posts: 646 |
Busy and test the board. CSU? Run a PRI capture in monitor.
[This message has been edited by gkar (edited January 04, 2005).]
|
|
|
|
|
Joined: Mar 2002
Posts: 3,630
Moderator-Avaya, Nortel
|
|
OP
Moderator-Avaya, Nortel
Joined: Mar 2002
Posts: 3,630 |
I finally got them to admit the protocol was wrong. Once they changed it, viola!
|
|
|
|
Forums84
Topics93,877
Posts636,989
Members49,670
| |
Most Online5,661
May 23rd, 2018
|
|
|
0 members (),
26
guests, and
15
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
