I have a customer where we were thinking that there might be something wrong with their CPU (NIC) port
So we ordered a new CPU 7.88
Their current CPU is 7.0
This is a two cabinet system
I backed up a CPU and I am loaded it into my demo system so I could eliminate downtime
However when I plugged in the new CPU some of the extensions are not correct especially the one in the phone room that I’m staring at
I also only see one cabinet where I could see two cabinets on the original CPU
Very strange never seen anything like it
Just wondering if I am doing something wrong as far as loading the system into my demo system prior to installing it into the current system
|