I have the manual but I have a question. I have 2 CO lines that ring at station 10. I want them to ring at station 15 as well. Here is what I did:

In program mode
SPKR 81 HOLD
SPKR 005# (logical port for dn 15)
then pushed the buttons on the phone associated with Co 1 and CO 2
HOLD
SPKR ## HOLD
SPKR ## HOLD

Where am I missing it?

Thanks

What type of phone on station 15(005)?

All of our stations are DK2020SD

You might try using program 39 for station 005 and select the buttons you want your CO lines on and enter the CO line number (probably 001 and 002).

If you don't want to assign buttons on the station you can also use *81 to assing the ring to the station. There's a great logic diagram in the programming manual on page 3-181.

The intercom button represents line 1 and the line one button represents line 2.
JBW

Also, make sure port 005 has access to lines 1 and 2 in program 40.

JBW had the answer I needed on this. I was pushing the buttons corresponding to the CO lines. I used prgm 81 again and used button 1 and button two... All is well. Thanks everyone...