Greetings,
My office had a Strata DK 280 installed and had 8 rollover lines. We recently moved and took the system and phones with us.

I get the pleasure of installing it in our new office, but only have four rollover phone lines. Taking an incoming call works great, but when trying to place a call, the phone is opening line 8, not line 4.

The programming manual is not very newbie friendly so I don't know what all the abbreviations mean.

I've never prgrammed anything on this machine... with that in mind... can anybody throw me a bone?

Thanks in advance!

Josh Cossiboon

ooops

[This message has been edited by KENB (edited May 09, 2005).]

take them out of prog 16
if you want the buttons off the phones
in 39

Go to program 39 check out the key strip assignments if you are using line groups you should see 601 or 60_ something where you access outside lines. Then go to program 16 and remove co lines 5-8 in that group (example 601 will be group 01) also remove the co lines in group 00

petersog -- I think you meant 301, not 601. In program 39, the pooled line keys are programmed as 301,302,303, etc.

------------------
fingerlakestelecom.net

thanks for the correction