setting new IP address for CIX 100 - 09/09/12 03:13 AM
I can go into 916 and read the IP address of a system, but emanager is just not letting me create a new contact and connect and it's driving me crazy. This is twice in a row with a 670 and now a 100 so either I've gotten so old I can't create a new contact right or my computer is screwed up.
Once I am in 916, how can I change the value back to default so I can just use a crossover cable and get this job done? I need to put in the 192 etc. and SAVE it.
I am putting in the community name correctly with the one capital needed, hoping that they didn't put in some other community name and if they did, what would I do then?
When I am creating a new account, the company names and all don't really matter, I am putting in the IP address listed in 916 and my IV4 adress in the computer is the same for the first three sections an different in the fourth section so I don't have a conflict there.
Getting too old for this stuff, Thanks, Bracha
Once I am in 916, how can I change the value back to default so I can just use a crossover cable and get this job done? I need to put in the 192 etc. and SAVE it.
I am putting in the community name correctly with the one capital needed, hoping that they didn't put in some other community name and if they did, what would I do then?
When I am creating a new account, the company names and all don't really matter, I am putting in the IP address listed in 916 and my IV4 adress in the computer is the same for the first three sections an different in the fourth section so I don't have a conflict there.
Getting too old for this stuff, Thanks, Bracha