IPT-2010-SD program mode - 07/14/16 03:26 PM
WE have 3 used IPT-2010-SD phones that i cannot enter programming mode to setup for our system. I was able to get in once on one of them but that was it.
It is a CIX100.
I am pressing the 3,6,9,Hold and nothing.
It says "IPAddress setting..." and then "Can't set IP Address"
When I was in that one time I noticed the phone was set to Manual IP.
Any advice is greatly appreciated.
Thanks
It is a CIX100.
I am pressing the 3,6,9,Hold and nothing.
It says "IPAddress setting..." and then "Can't set IP Address"
When I was in that one time I noticed the phone was set to Manual IP.
Any advice is greatly appreciated.
Thanks