atcomsystems.ca/forum
Posted By: drdick MOH Question for 616Flex - 05/29/04 10:16 AM
The manual says that I need INPUT of 2KOhm impedance.(page500-13) I'd like to hook up an old boombox for the music source. I thought the speaker output on these was around 8Ohms so I have no clue how to hook this up. Would appreciate anyone's help and advice.

Can I just plug in where headphones go on the radio and punch those 2 wires down to pins 42 and 17 on the J1?
Posted By: DrPbx Re: MOH Question for 616Flex - 05/29/04 10:49 AM
Yes, just plug into headset jack & adjust volume.
Posted By: drdick Re: MOH Question for 616Flex - 05/29/04 06:42 PM
Thanks for the help.
Posted By: drdick Re: MOH Question for 616Flex - 05/30/04 05:18 PM
The beat does not go on!

I punched down the wires from the radio to the block. I can put a test set on the pins and here the music.

I enabled MOH in programming.

I dial 8 but don't get any music. Also there is no music on hold.

What's up with this? did I not program something I should have?

TIA
Posted By: drdick Re: MOH Question for 616Flex - 05/30/04 06:00 PM
Nevermind! One wire on my punchdown was not making good contact.
© Sundance Phone System Forums - VOIP & Cloud Phone Help