Can I use DISA on a XTS system on CO line 6 of 6 to allow the caller direct access to his secretary without going through the secretary that normally answers the incoming calls?

If yes how do I do this. I have a manual but have no expreience in programming this system.

Thanks in advance,

Tom

You need to setup the co for a disa call. Section 40 button 7. Set it for 24 hour. When you call into that line you must enter the DISA default password; then you get an intercom dial tone. Then just dial the extension number of who you want to reach.

It is possible, you are just using line 6 for DISA use only then.

Is this the only application you want to use the DISA for? If so, why not have the line just directly ring the secretary's phone?