hello guys i am bench setting up programing on an stse with vm. everything is new. and everything is working ok except caller id. none on the display and none on the smdr. i cant seem to find the cause. the line has caller id on it and is a pots line. i have a call id button programed and lit up. is there anything i may had forgotten. thanks dave
Please reinstall the call id. board in upper right of ksu or try a different one as well.
Making sure the top as well as the bottom of the
cards pins are in proper alignment of the mother board.
Also put a ring delay on the lines of atleast 3 seconds. Fl. 4o, page c, button 2.
its working good now. thanks, dave
Dave:
Would you mind sharing what the resolution was?
DAVETEL
Please let us know,what was the outcome of your problem?