STSe Flash VM willnot bounce back to VM Box - 06/04/10 06:43 AM
Got a STS that experienced a repeated power outage the other day.
Once I got onsite, discovered the system was in a continuous boot-up / rest loop.
Once I deactivated the memory battery, the system booted fine but with defualt programming, of course.
All was fine until we tried to program LNR on buttons. The System flat out refused to accept the command. I reinitialized and still it took 3 tries to get it to accept button programming other than default.
Now the issue is the VM will not Call Fwd N/A nor Busy back to the VM unit. (VM does answer and will transfer to proper ext just fine)
Ive programmed Feature 50 page C - Internal Busy and N/A Fwd without success. Ive rest the VM also.
Any ideas?
Once I got onsite, discovered the system was in a continuous boot-up / rest loop.
Once I deactivated the memory battery, the system booted fine but with defualt programming, of course.
All was fine until we tried to program LNR on buttons. The System flat out refused to accept the command. I reinitialized and still it took 3 tries to get it to accept button programming other than default.
Now the issue is the VM will not Call Fwd N/A nor Busy back to the VM unit. (VM does answer and will transfer to proper ext just fine)
Ive programmed Feature 50 page C - Internal Busy and N/A Fwd without success. Ive rest the VM also.
Any ideas?