Unit appears complete and functional
I need help

Need to know what to connect to the CPU to config the unit.

Any help would be appreciated

hardware

case
2 batteries
CPU B 500 U1 0
SLI (8) -U1 0 ETU
3x
ESI (8) -U1 0 ETU
PRT (1) -U20 ETU
ECR -U1 0 ETU
VMS (8) -U1 0 ETU

You need an MIFM Board and Cable.....Manuals for installation and programming would also be helpful.

added to the list.. thanks

any idea on cost.

based on my listed cards, what type of telco service is this unit set up for?

cpu=the processor
sli8=8 port analog station card
esi8=8 port digital station card
prt=pri (this is your trunks)
ecr=relay/paging card
vms8=8 port voicemail with a hard drive

not listed but you will have it too,
clkg=clock card (on the cpu) for the pri timing

programming can be done via any digital phone with a display. or you can get a mifm card and the sat software to do it via a pc.

so the pri card would need to be replaced with other hardware to set the unit to work with standard phone lines. Right?

Anyone need the paging card.

yes..........you'll need a coi4 (4 lines), coi8 (8 lines), coid8 (8 lines with callerid)

it all depends on how many lines you need.

the ecr card supports multi zone paging (3 zones)

ring over page

general purpose relays

etc