Hi everyone,
This is my first time at the board and this may have been addressed prevoiusly. If so I appologize. I need to change the display name on certain internal extensions here in the office. i.e. ext. #211 to read Ruby instead of Janet. We have had some personnel changes over the past two years and it has fallen on my lap to change the display to read the correct ext and name.

Thanks so much!

Go offline and enter the following:
To enter programming mode, the station must be idle
(on-hook). Perform the following procedure to go off-line.
1. Press ******.
2. Press ****.
3. Dial ******** in sequence. The Multiline
Terminal LCD indicates program mode is now
active.
Programming Procedures
1 Go off-line.
2 Press LK4 + 18 to access the Memory Block.
3 Use the following to enter data:
*to move the cursor left
#to move the cursor right
0-9 to enter numeric data or Tel Port No.
– OR –
Conf go to next assigned Tel Port No.
Hold clear data when cursor is at setting data
Redial+1 to enter A for Port Numbers 100~109
Redial+2 to enter B for Port Numbers 110~119
Redial+3 to enter C for Port Number 120
Press transfer to write the data and display the next Memory Block.
5 Program the next Memory Block or press speaker to go back on-line.

[This message has been edited by DrPbx (edited April 01, 2005).]

Please do not post system programming access codes. Talk off line & comunicate codes to each other.

------------------
Bound to cover,
just a little more ground.