atcomsystems.ca/forum
Posted By: nikola69 Message Button Problem - 06/10/05 07:45 AM
Message button on users phone flaky. Immediately after connecting phone you press it and it takes you to VM. Three seconds later you press it and nothing. Where can I program this button or how to reset?
Posted By: Tip&Ring Re: Message Button Problem - 06/10/05 02:45 PM
We need to know what system you are using.


DJ

------------------
Watson to Bell: "It must be working, all I get is a busy signal"
Posted By: nikola69 Re: Message Button Problem - 06/10/05 03:03 PM
Duh, sorry. Elite IPK with EliteMail VMS. This is a 16 button display phone sepcifically.
Posted By: chrislebeck Re: Message Button Problem - 06/10/05 04:58 PM
the button has to be set as a feature access in system programming.


then you would go to the phone in question
feature
redial
1
(pilot ext number of the vm)
feature
Posted By: nikola69 Re: Message Button Problem - 06/12/05 07:10 AM
Chris! Yes, programming it is where I'd like to be but how the heck do I get to that? I have the SAT but cannot find the right memory spot to amend/add this setting for either the message or directory buttons. As well, pressing F-R-1-Pilot number results in an error condition being shown in the display. Any hints?
© Sundance Business VOIP Telephone Help