our systemm is a NEC 2000 IPS. The problem is i foward all calls to my cell phone and when ther is a call from the out side the switch board can not release the call till i answer my cell phone.
If I could get any help in this matter it would be helpful. Thank You Brad
Check this program's settings:
08>206=0
08>253=0
08>324=0
08>028=0
08>063=0
Verify Program 360 for route to route connection, although this is most likely correct or it wouldn't work at all.
D
Thank you for your responce
I changed
08>206 From a 1 to 0
08>253 From a 1 to 0
08>324 From a 1 to 0
and
08>028
08>063
were set to 0
and the switchboard still can not release the call
Command 360 looks alright.
If you have any other ideas it would be helpful. Brad
That's odd, because I had the exact same issue with a CP24 I had to C-load and the 08 commands are what got me going ok.....
You may need to contact NTAC if you can after the holiday.
D
I will contact then on Monday thanks for all your help.
Brad
Don't have a manual to hand (in Dempasar airport going home) but there is another 08 Cmd around the 400s I think for post dialling on an ISDN call which will give this exact problem if set wrong.
R4+Z I looked in the 400's but I could not find anything that helped the problem.
Brad
Try 410>03>xx & set to 00.
DrPbx that command is set to 410>03:00.
Brad
Try Cmd 08 de 405 If I remember correctly it's worded a bit strange in the manual and you wouldn't expect it to have the effect it does! First time I experienced the problem I had to get TAC to find the solution for me and it took them a day to get back to me with the answer! Let us know if it works as I've lost the email that has the specifics in it.
When I changed the command it made it so the call would not even go through to the cellphone. I still have all other comand changed as listed from doghart. Any other ideas would help.
Brad