Ive just installed an IPK and cant seem to find the paging port, as i remember there was a port next to the MOH port but there is nothing there or is it connect to one of the positions on the 66 block.Any help would be appreciated

It is the RCA connection next to the MOH connection on the side of the cabinet.

To dial over external page dial 55, 56, 57, 58, or 59. 59= all call plus external page by default.

D

There is no RCA connection other than the MOH. There is only 1 RCA connection there

Sounds like an old Elite 192 (black in color??) that had to use the ECR card for paging out..

Then it must be an elite 192.

Paul is correct, you will need an ECR card.

D

Yea thats exactly right, I did a little research and found exactly that. I have ordered the card and should have it here in a couple of days. Thank you all

If I recall correctly, the CPU's for the Elite 192 & The IPK I were inter-changable between the 2 differnet KSU's. The Elite 192 KSU only had a RCA port for MOH while the IPK KSU had 2 for MOH & Ext Page. I had IPK II CPU's work in an Elite 192 KSU, however, NTAC would not support it.