SV9100 with a SVR2 blade and all proper premium licenses.

I'm not having any luck connecting to the SVR2 server. On the 9100, I've enabled server availability in 10-69-01, entered an IP in 10-69-02 and made the port=8080 in 10-69-03. restared the 9100.

I've tried with a patch cable in Eth 0 and in Eth 1, but I cannot connect. Can't ping it either. Looked in the UC Suite manual and didn't find any help.

Any suggestions where I should look? Thank you!
Jim

10-69-03 I use 8888. 8080 is normally suite web access. You have to upate the ip address by connecting directly & changing from default.

Got it! Finally found the inServer config guide on ntac after searching for uc server. I'd been searching for uc suite and svr2 before. Everything is like a scavenger hunt. And I don't want to play anymore.

Thanks for the help DrPBX.

Jim

Yes, that manual was very hard to find on NTAC.