Hello

Due to a faulty motherboard I have replaced an XN120 CCU with ISDN2. When I loaded the back-up everything except the "line data" was applied subsequently no lines. Would appreciate any advice regarding steps to take to try and isolate what is causing this problem. Thanks in advance.

My brains beginning to melt, when I go into Advanced settings, Card config the Remove card option is highlighted but No port settings. Drag and drop the 2BRIU card port settings are updated to T-point 04-07. When I check the slot in the programming the details have been updated. save the config disconnect the software, reconnect download config and back to square one. Have I got a faulty card or is some secret masonic handshake required to get the thing working?