atcomsystems.ca/forum
Posted By: erniejoey SV9100 With InDECT - 02/07/20 07:17 PM
Has anybody installed the new InDECT application yet. We have installed the software on the LUA, loaded all firmware, bootloader, etc.
The SV9100 is upgraded to 10.30.50 and programmed according to the training course. All the licenses are in place. I can create the InDECT in LUA but the AP 400s DAP is not being recognized. The network is set for DHCP. Am I missing something? Any help would be greatly appreciated. Thanks...
Posted By: helpifican Re: SV9100 With InDECT - 02/07/20 07:34 PM
Did you get a PARI code from NEC?
PARI – The PARI (Primary Access Rights Identifier) code is a unique eight-digit
identifier for InDECT. This provided to you when your InDECT order is processed.?
You must ensure you use an InDECT PARI from NEC. PARI codes purchased for
other IP DECT solutions including IP DECT Lite/Unlicensed DAP Controller/Full
DAP Controller systems cannot be used in conjunction with InDECT.
Posted By: erniejoey Re: SV9100 With InDECT - 02/07/20 11:07 PM
Yes we did apply the PARI code. Have you installed a InDECT. Did you have any problems. Thanks again...
© Sundance Phone System Forums - VOIP & Cloud Phone Help