I have a new SL2100 with IP phones going in, and I want to keep the phone system separate from the lan network. I have my own PoE switch for the phones.

If DHCP Server Mode is enabled in 10-13-01, will it just start assigning addresses in the VoIP daughter board range? I don't see anywhere to specify a range of addresses to use, like you would in a lan situation. And when I try it, I get dhcp server not found error on the phones. I did log into the phones and tell them to use dhcp.

Thank you.
Jim

Look in 10-14

It would have bit me if it was any closer.
My server not found error was coming from another place, of course.

It was quite a busy week last week. Once I got all the addresses straightened out, it's a nice IP system. Got it installed Monday.

Thanks.
Jim