atcomsystems.ca/forum
Posted By: advanced Feature code for Voice over on NEC Dterm - 02/25/21 02:35 PM
I have a client that has a NEC IPK system and 1 phone is always on Voice Over mode.
(When any internal extension calls this phone, the ICM always goes over the speaker rather than ring the extension). I was able to find how an extension can call Voice over, but unable to find how to remove the extension in this mode.
I'm guessing the user must of dialed a feature code.
Thanks
Posted By: dans Re: Feature code for Voice over on NEC Dterm - 02/25/21 06:05 PM
Are you sure this is a IPK and not the IPK II?
If its a IPK the display phones will have 1 line
If its a IPK II the display will have 2 lines

I'm asking because I don't know if the IPK gives the users the ability to toggle between voice announce and ringing, the IPK II does

IPK II: To enable handsfree answer back press the speaker key for intercom dial tone, dial 721
For forced intercom ringing press the speaker key for intercom dial tone, dial 723
Yes it was a IPK II system & yes cleared by dialing 723.
Thanks
© Sundance Phone System Forums - VOIP & Cloud Phone Help