atcomsystems.ca/forum
Posted By: dialtone cdrom drive - 05/01/01 10:40 PM
o.k. guys, don' laugh, mayble I made a mistake. I have an old packard bell 133 mhz computer which I did not use much. I decided to reformat the hard drive and take it back to its original state.
My problem is that the cdrom don't work. During boot up, it shows being installed but when I go to the control panel, it don't show up. Set up shows it as secondarly principle
Do anyone have any help to offer. Thanks
Posted By: dtmf Re: cdrom drive - 05/01/01 11:08 PM
You need to install a cdrom drive program so you can execute it. I think I have a old program on a floppy if you need me to e-mail it to you just give me a yell.
dtmf
Posted By: mpoe Re: cdrom drive - 05/04/01 09:46 PM
did you make a boot disk prior to reformat?
if not go here, this site will help
good luck
https://www.bootdisk.com
© Sundance Phone System Forums - VOIP & Cloud Phone Help