atcomsystems.ca/forum
Posted By: tony comdial 308 - 04/21/01 08:26 PM
I read the procedure for activating a new CO line on the 1024...would this be the same for an 308 (which is what i am looking to add the new CO)
Posted By: dtmf Re: comdial 308 - 04/21/01 10:39 PM
tony
No the 308 has different programming.To activate a line on the 308 you have to do the following.
In "Line Class Of Service" make sure the line isn't disabled.
With handset down at station 10
Intercom *746*
Press the line you want to add
Dial 2
Dial *
Press (Monitor or Speaker)to end

For Station Class Of Service
Intercom *746*
Dial station number (10-17)
Dial 7
Press line (Key1-3)
Dial (1-3)
Dial *
Press (Monitor or Speaker)to end
Hope this helps
dtmf
Posted By: tony Re: comdial 308 - 04/24/01 06:23 PM
I attempted the procedure you described without success. At station 10, when i pressed intercom and dialed *746*, the system returned fast busy. This is a Comdial Executech 308 system where all sets have line 3 setup as speed call key. What did I miss? Thanks for the reply.
Posted By: openwire Re: comdial 308 - 04/24/01 06:34 PM
Try ITCM*#746*
Posted By: dtmf Re: comdial 308 - 04/24/01 08:00 PM
tony
How old is this system? There should be a white tag on the right side of the KSU that will tell you exactly what you have. If ITCM *746*gets you in.Then the steps in my other post will set up line three on your system.If ITCM*#746* gets you in then you have a (NO system) which programs like a 1024. Make sure you are programming at station 10 with the handset in the craddle.Let me know what happens.
If you would like I can fax you the program charts for either system.
dtmf

[This message has been edited by dtmf (edited 04-24-2001).]
Posted By: Test-ok Re: comdial 308 - 04/24/01 08:27 PM
tony
you didn't miss anything. dtmf gave you the programming for the older 308 (tan) front, I think yours has a black front case on it, which is an "NO 308" which will program like openwire said ITCM*#746* and follow the 1024 manual you have. A fast busy means an error, make sure the handsets in it's cradle and your at station 10. (to find station 10 go to a phone and dial 0, where it goes, is station 10) try to use a phone that's in a back room somewhere because if ya try the test above from station 10 you'll be trying to call yourself. Hope that wasn't confusing. [Linked Image from sundance-communications.com]
© Sundance Phone System Forums - VOIP & Cloud Phone Help