I have a DSU II and I am trying to set up a caller id unit {CID08-c} it is a 8 port. It has 4 dip switches and i do not know where to set them. So if any one could help that would be great.

DSU II COM2 only RJ-11 Jack Four-conductor, rolled cable, RJ-11 plug
on each end.
9600, 8, N, 1

The Comdial caller ID device has a bank of Dual In-Line Pin (DIP) switches located on its front panel. This
bank of switches is labeled SW1.
There are no DIP switches for setting baud rate, data bits, parity, and stop bits. These parameters are fixed at
9600 baud, 8 data bits, no parity bits, and 1 stop bit (9600, 8, N, 1).
When installing multiple caller ID devices, set switches SW1-1 through SW1-4 to the settings detailed in
Table 1. The switch settings must match those in the table corresponding to the trunk number you are
attaching to port one of the caller ID device.
A DIP switch is ON when it is in the UP position.


If you are installing 1 box turn all switches off. 2 boxes turn all switches off and switche 1 on.


------------------
BIGDOG3c


PARALLEL TECHNOLOGIES INC.

WWW.ABUGSEYEVIEW.COM